Installation guide

16
3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with a
5/8" (15.9 mm) combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
“LP” is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Natural Gas to Propane
Gas)
1. Remove burner cap.
2. Using a Phillips or Quadrex
®
screwdriver, remove the burner
base.
NOTE: Reinstall one of the screws through the range
cooktop to hold the orifice spud holder in place while
removing and replacing the orifice spuds.
A. Igniter electrode
B. Gas tube opening
C. Burner cap
D. Burner base
3. Apply masking tape to the end of a 9/32" (7 mm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice spud
and remove by turning it counterclockwise and lifting out.
Set gas orifice spud aside.
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
4. Remove the cardboard orifice spud holder shipped in
the literature package in the oven. Gas orifice spuds are
stamped with a number, marked with one color dot, and
have a groove in the hex area. Replace the Natural gas
orifice spud with the correct propane gas orifice spud.
A. Propane groove
Refer to the following chart for correct propane gas orifice spud
placement.
Propane Gas Orifice Spud Chart for Surface Burners
Burner
Rating
Color Size (mm) ID
Number
Placement
14,200 BTU Yellow/
Orange
1.16 mm L116 LF
8,000 BTU Yellow/
Black
0.88 mm L88 LR
14,200 BTU Yellow/
Orange
1.16 mm L116 RF
5,000 BTU Yellow/
White
0.70 mm L70 RR
8,000 BTU Yellow/
Black
0.88 mm L88 CTR
NOTE: Refer to the Model Number and Serial Number Plate
located on the oven frame behind the top right side of the oven
door for proper sizing of spuds for each burner location.
5. Place Natural gas orifice spuds in the cardboard orifice spud
holder.
6. Replace the burner base using both screw.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
A
B
C
D
Side view before
Side view after
E
NG
LP
NG
LP
A
B
A
C
D
A
B
C
D
QUADREX is a registered trademark of Quadrex Consulting Inc.