Control Guide

3
KEYPAD FEATURE INSTRUCTIONS
DELAY TIME Delayed start The Delay Start keypad is used to enter the starting time for an oven function with a
delayed start. Delay Start should not be used for foods such as breads and cakes
because they may not bake properly.
To set a Timed Cook or a Delayed Timed Cook, see “Cook Time” section.
COOK TIME Timed coking Timed cooking allows the oven to be set to turn on at a certain time of day, cook for a set
length of time, and/or shut off automatically.
To set a Timed Cook or a Delayed Timed Cook, see “Cook Time” section.
RAPID PREHEAT RAPID oven
preheating
Provides the fastest preheat time for the BAKE function.
1. Press RAPID PREHEAT.
2. The current setting will be displayed.
3. Press the “1” keypad to adjust the setting.
4. Press START or CANCEL to exit and display the time of day.
NOTE: This feature should only be used for one-rack baking. Unused racks should be
removed prior to Rapid Preheat. A standard rack should be used for Rapid Preheat. If
preheating for the Bake cycle has already started, Rapid Preheat may be started directly
by pressing RAPID PREHEAT.
AQUALIFT SELF
CLEAN
Aqualift
®®
self-
clean cycle
See the “Clean Cycle” section in the Owner’s Manual.
START
hold 3 sec. to lock
Oven control
lockout
No keypads will function with the controls locked.
1. Check that the oven is off.
2. Press and hold START K keypad for 3 seconds.
3. A tone will sound and “Control Locked” will scroll, and then “Locked” will be displayed.
4. Repeat to unlock.
SETTINGS/CLOCK Energy save
1. Press SETTINGS/CLOCK until “ENERGY SAVER” is displayed.
2. The current setting will be displayed.
3. Press the “1” keypad to adjust the setting.
4. Press CANCEL to exit and display the time of day
If Energy Save is ON, the range will go into Sleep mode after 5 minutes of inactivity.
Any keypad press will activate the display. If Energy Save is OFF, the display will be
on at all times.
AquaLift
®®
Self-Cleaning Technology
AquaLift
®
Self-Cleaning Technology is a first-of-its-kind cleaning
solution designed to minimize the time, temperature and odors
that ordinarily come with traditional self-cleaning methods. With
AquaLift
®
Self-Cleaning Technology, an exclusive coating on the
interior of the oven is activated with heat and water to release
baked-on soil. To use AquaLift
®
Self-Cleaning Technology, simply
wipe out loose debris, pour water into the oven bottom and run the
AquaLift
®
Self-Cleaning cycle. When the cycle finishes in under 1
hour at a lower temperature than traditional self-cleaning
methods, just wipe out the remaining water and loose debris. See
the “Clean Cycle” section in the Owner’s Manual for more detailed
instructions. For additional information, frequently asked
questions and videos on using AquaLift
®
Self-Cleaning
Technology, visit our website at
http://whirlpoolcorp.com/aqualift.
Surface Temperature
When the range is in use, all range surfaces may become hot,
such as the knobs and oven door.
Warming Drawer, Storage Drawer, or Baking Drawer (On
Some Models)
When the oven is in use, the drawer may become hot. Do not
store plastics, cloth, or other items that could melt or burn in the
drawer.
Oven Vent
The oven vent releases hot air and moisture from the oven, and
should not be blocked or covered. Do not set plastics, paper or
other items that could melt or burn near the oven vent.
Electronic Oven Controls
Control Display
The display will flash when powered up or after a power loss.
Press CANCEL to clear. When oven is not in use, the time of day
is displayed, unless the range is in Energy Save mode. During
Energy Save mode, the display will be blank. Indicator lights show
functions that are in use.
Tones
Tones are audible signals, indicating the following:
One Tone
� Valid keypad press
� Oven is preheated (long tone).
� Function has been entered
� Reminder, repeating each minute after the end-of-cycle tones