Dimension Guide

Electric Dryer

PRODUCT MODEL NUMBERS

W10562335B

08/2013

WED8000B, WED8100B,

WED8500B, WED8900B

Back view

Side view

Models with riser

DRYER DIMENSIONS

Models without riser

Back view

Side view

Bottom view:

NOTE: Most installations require a minimum of 5" (127 mm)

clearance behind dryer for exhaust vent with elbow. See “Venting

Requirements.”

All dimensions show recommended spacing allowed,

with tested spacing of 0" (0 mm) clearance on sides

and rear.

■ Additional spacing should be considered for ease

of installation and servicing.

■ Additional clearances might be required for wall,

door, and oor moldings.

■ Additional spacing should be considered on all

sides of the dryer to reduce noise transfer.

■ For closet installation, with a door, minimum

ventilation openings in the top and bottom of the

door are required. Louvered doors with equivalent

ventilitation openings are acceptable.

■ Companion appliance spacing should also be

considered.

Spacing for recessed area or closet installation

PAGE 1
Electric Dryer PRODUCT MODEL NUMBERS WED8000B, WED8100B, WED8500B, WED8900B DRYER DIMENSIONS Models without riser Models with riser Side view Bottom view: Back view Side view Back view NOTE: Most installations require a minimum of 5" (127 mm) clearance behind dryer for exhaust vent with elbow. See “Venting Requirements.” Spacing for recessed area or closet installation All dimensions show recommended spacing allowed, with tested spacing of 0" (0 mm) clearance on sides and rear.
PAGE 2
ELECTRICAL REQUIREMENTS To supply the required 3 or 4 wire, single phase, 120/240 volt, 60 Hz., AC only electrical supply (or 3 or 4 wire, 120/208 volt electrical supply, if specified on the serial/rating plate) on a separate 30-amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended. Connect to an individual branch circuit. VENTING REQUIREMENTS Exhaust venting: Exhaust your dryer to the outside. 4" (102 mm) diameter vent is required.