Quick Start Manual

18
1. Remove door from dryer
2. Move the door strike
Using a TORX
®
T25
®
screwdriver, remove the 2 screws
securing the door strike to the door frame of the dryer. Rotate
the strike 180° and attach to the opposite side of dryer door
frame, as shown.
3. Remove inner door from outer door
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, remove the 10 screws securing the
inner door to the outer door. Lift off the inner door and set
aside.
IMPORTANT: If the protective lm has not yet been removed
from the dryer, peel the lm from the dryer door before
proceeding.
Using a TORX
®
T25
®
screwdriver, remove the 4 screws
securing the door hinge to the dryer and lift up and out to
remove the door. Place the door on a soft towel or other
non-scratch surface. Reinstall the 4 screws in the holes.
Reverse door swing round-shaped door – single handle
#2 Phillips screwdriver
Min. 8" long TORX
® †
T25
® †
screwdriver
Tools needed:
†
® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.
DOOR REVERSAL (OPTIONAL)
The following instructions are for models with a round and
square-shaped doors.