Quick Start Manual

9. Reinstall inner door assembly

Position the door with the inside of the door facing up.

Reinstall the 10 screws securing the inner door to the

outer door.

10. Reinstall door on dryer

Using a TORX

T25

screwdriver, remove the 4 screws on the

dryer. Insert the tabs on the hinge into the mounting slot and

slide down to engage the top tab. Secure in place with

the 4 TORX

T25

screws removed earlier.

Bottom

of door

1. Remove door from dryer

IMPORTANT: If the protective lm has not yet been removed

from the dryer, peel the lm from the dryer door before

proceeding.

Using a TORX

T25

screwdriver, remove the 4 screws

securing the door hinge to the dryer and lift up and out to

remove the door. Place the door on a soft towel or other

non-scratch surface. Reinstall the 4 screws in the holes.

Reverse door swing round-shaped door – double handle

2. Move the door strike

Using a TORX

T25

screwdriver, remove the 2 screws

securing the door strike to the door frame of the dryer. Rotate

the strike 180° and attach to the opposite side of dryer door

frame, as shown.