Installation Guide

21
Select UL Listed/CSA Approved twist-on wire connectors of
the proper size. See the “Tools and Parts” section at the front
of the guide for part details. Connect wires, black-to-black and
white-to-white, using the twist-on wire connectors.
NOTE: Do not pre-twist stranded wire. Twist on wire connector.
Gently tug on wires to be sure both are secured.
Place wires inside terminal box. Replace the cover by inserting
the hooks of the terminal cover into the slots in the floor of the
terminal box and sliding the cover tight against the back wall
where wires come in. Make sure wires are tucked inside the
box and not pinched by the cover.
Put the terminal box back on the crossbar with the tab in place.
Use a
1
/
4
" nut driver and the screw removed in Step 51 to
secure the terminal box to the crossbar.
Once the terminal box has been remounted on the dishwasher,
tuck any excess length or slack over nearby components or clip
them back into the nearby clips to help keep them off the floor.
56. Direct wire – connect
remaining wires
57. Direct wire – reinstall terminal
box cover and wires
Install a UL Listed/CSA Approved metallic strain relief.
See the “Tools and Parts” section at the front of the guide
for part details and orders.
Form bare ground wire into a U-shaped hook. Wrap ground
wire hook clockwise around the ground connector screw on the
raised floor inside the box and under the dishwasher. Securely
tighten ground connector.
54. Install strain relief
WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
55. Direct wire – connect ground wire
Ground
wire
Ground
wire
Ground
screw
Washer