Installation guide

C _ _,_ _ _ _'_,_i_'_

Check that power supply wire or cord does not touch dishwasher

motor or lower part of dishwasher tub.

Option A, Install Access Panel - Plastic Panel

Place the plastic access panel against the dishwasher leg.

Check that the lower edge of the access panel touches the floor.

Adjust if necessary.

Using a flat-blade screwdriver, turn the fasteners V4turn clockwise

to lock into place. The fasteners slot will be straight up and down

when properly locked.

Option B, Install Access Panel - Metal Panel

Check that grounding clip is attached to the lower panel. Position

the lower panel behind the access panel. On some models there

is insulation on the access panel that must fall behind the

insulation on the lower panel.

Hold the 2 panels together and place them against dishwasher

leg. Using a Phillips screwdriver or V4" nut driver, reinstall the

screws through the holes in the access panel, and the slots in the

lower panel.

Check that the lower edge of the lower panel contacts the floor.

Adjust if necessary.