Cycle Guide
DISHWASHER FEEDBACK
CONTROL PURPOSE COMMENTS
START /
RESUME
Press to start or resume a wash
cycle.
If the door is opened during a cycle or power is interrupted,
door is closed and Start/Resume is pressed.
NOTE:
Start/Resume. If door is not closed within 4 seconds, the Start/
and cycle will not start.
CANCEL /
DRAIN
Push to reset any cycle or options
during selection. Push to end a
cycle once started.
needed). Let dishwasher drain completely.
DELAY
Runs the dishwasher at a later
time.
To delay the start:
1. Select a wash cycle and options.
2. Press DELAY. Each time you press Delay, it will display the
3.
NOTE: If the door is opened, such as to add a dish, the Start
Cancelling a Cycle
1. Open the door slightly to stop the cycle. Wait for the
2.
3. Close the door, and the dishwasher starts a drain cycle (if
after 3 minutes.
Changing a Cycle After Dishwasher Is Started
You can interrupt a cycle and restart the dishwasher from the
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop, then open the door completely.
2.
restarting the new cycle.
3.
4. Select new cycles and options.
5. Press START/RESUME.
Adding a Dish After Dishwasher is Started
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop, then open the door completely.
2.
If it is open, the wash cycle has already started and adding a
dish is not recommended.
3.
cover is closed), you may add a dish.
4.
again and close the door within 4 seconds.