Installation Guide

23
Helpful Tip: Remove disposer knockout plug.
1. Using a hammer and screwdriver, knock
plug into disposer.
2. Use needle-nose pliers to remove plug.
3. Connect rubber end of drain hose
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
4. Attach drain hose to air gap with large
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position. If the drain hose was cut, use
a 1
1
/
2
" to 2" (38 to 50 mm) screw-type
clamp (not provided).
5. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from air gap to disposer inlet.
Option C: Waste disposer – with air gap
Large drain
hose clamp
Drain hose
Screw-type clamps
Air gap
Rubber hose
connector
Drain trap
Disposer inlet
1
2
Rubber
end
3
4
5
1. Fit rubber end of drain hose
to waste tee and cut if needed.
NOTE: Do not cut ribbed section.
2. Attach rubber end of drain hose to
waste tee with a large drain hose clamp
(provided). Use pliers to squeeze clamp
open and move into position. If the drain
hose was cut, use a 1
1
/
2
" to 2" (38 to
50 mm) screw-type clamp (not provided).
Option B: No waste disposer –
no air gap
Large drain
hose clamp
Drain hose
Drain trap
Waste tee
1
Rubber
end
2