Use and Care Manual

9
OPTION SELECTIONS
OPTIONS CAN BE
SELECTED
WITH
WHAT IT DOES ADDED
TIME TO
CYCLE
ADDED
WATER
GALLONS
(LITERS)
(varies by
model)
Runs dishwasher at a later time. Select a wash cycle
and options. Each time you press the Delay keypad, it
will display the next available delay time. Press DELAY.
Press the START/RESUME keypad. Close door firmly.
NOTES:
■ The dishwasher remembers the last Delay you
selected. To reset the delay time to something
other than what is displayed, continue to press
the Delay keypad until the desired delay time
is reached.
■ Anytime the door is opened (such as, to add a
dish), Start/Resume must be pressed again to
resume delay countdown.
Available with
any cycle
Delays start of
a cycle up to
24 hours.
NA NA
Raises main wash temperature to improve cleaning
for loads containing tough, baked-on food.
Sensor
Heavy
Normal
Soak & Clean
Raises the
main wash
temperature to
135°F (57°C).
0:05 to
0:13
0 to 3.86
(0 to 14.6)
Dries dishes with heat. This option, with the use of
rinse aid, will provide better drying performance. Plastic
items are less likely to deform when loaded in the top
rack. Use Heat Dry for optimum dry performance. Turn
the Heat Dry option off for air dry.
Extended Dry lengthens the time that Heat Dry is active.
This option with the use of rinse aid will provide better
drying performance.
Sensor
Heavy
Normal
Soak & Clean
Uses heating
element to speed
drying times.
Heat Dry option
defaults to On
when any cycle is
selected, except
for 1-Hour Wash.
0:08 to
0:46
0
(location of
“Sanitized”
indicator
varies by
model)
Sanitizes dishes and glassware in accordance with NSF
International NSF/ANSI Standard 184 for Residential
Dishwashers. Certified residential dishwashers are
not intended for licensed food establishments. Only
sanitizing cycles have been designed to meet the
requirements of the NSF/ANSI 184 performance
standard for soil removal and for sanitization efficacy.
There is no intention, either directly or indirectly, that
all cycles on a NSF/ANSI 184 certified dishwasher
meet the NSF/ANSI 184 performance standard for soil
removal and for sanitization efficacy.
At end of the cycle, the “Sanitized” indicator will glow.
If your load did not properly sanitize, the indicator will
flash at the end of the cycle. This can happen if the
cycle is interrupted or if the water does not reach the
required temperature. The light goes off when you open
and close the door or press CANCEL.
Sensor
Heavy
Normal
Raises the
main wash
temperature to
135°F (57°C) and
the final rinse
temperature to
156°F (69°C).
0:05 to
1:06
0 to 3.86
(0 to 14.6)
Avoids unintended use of dishwasher between cycles or cycle and option changes during a cycle.
To turn on Control Lock, press and hold CONTROL LOCK for 3 seconds. Control Lock light will stay on for a short time,
indicating that it is activated and all keypads are disabled. If you press any keypad while your dishwasher is locked,
the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked.
To turn off Control Lock, press and hold CONTROL LOCK for 3 seconds. The light turns off.