Installation Instructions

DIRECT WIRE CONNECTION

Using a

" hex-head socket, nut driver, or Torx

T20

screwdriver, remove terminal box cover. Retain for later use.

Install a UL Listed/CSA Approved metallic strain relief.

See the “Tools and Parts” section at the front of the guide

for part details and orders.

Route cable so that it does not touch dishwasher motor or

lower part of dishwasher tub. Pull cable through UL Listed/

CSA Approved strain relief in terminal box. Strain relief is not

supplied with the dishwasher. Owner must purchase a

screw-in type strain relief.

Select UL Listed/CSA Approved twist-on wire connectors (not

included) rated to connect your household wiring to 16-gauge

dishwasher wiring.

49. Remove terminal box cover

50. Install strain relief

51. Route cable into terminal box

IMPORTANT: Check that top of door does not contact screws,

brackets, or countertop. If it does, adjust leveling legs or use

the side attachment option.

Open door and check that space between dishwasher cabinet

opening, and tub is equal on both sides. If spacing is not equal,

loosen bracket screws and shift tub. Tighten bracket screws.

47. Check door clearance

48. Check inner spacing