Installation Guide

12
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed.
Be sure to measure the lowest point on the underside
of the countertop and the highest point on the floor.
Adjust both front and back leveling legs to the same height.
11. Measure cabinet opening
Dishwasher Height Adjustment Chart
Cabinet opening
height
Front legs
height A
Rear legs
height B
33
1
/
2
" (851 mm)
3
/
8
" (9.8 mm) Remove legs
and spacers.
34" (864 mm)
7
/
8
" (22 mm) 1" (25.4 mm)
34
1
/
2
" (876 mm) 1
1
/
8
" (28.8 mm) 1
1
/
4
" (31.3 mm)
Front legs – A
Rear legs – B
B
NOTE: If the minimum cabinet opening height is less than 33
7
/
8
"
(860 mm), the rear leveling legs and spacers can be removed for
additional clearance. This will allow the dishwasher to fit into a
33
1
/
2
" (851 mm) high cabinet opening, but the dishwasher will
be more difficult to move. (Measurements are approximate.
Rear and front leveling legs are preset at the factory for 34
1
/
2
"
[876 mm].)
Refer to the “Dishwasher Height Adjustment Chart” for height
of leveling legs needed for your cabinet opening.
Remove and discard the plastic rail cover on each side of
the dishwasher frame. To remove the plastic rail cover, push
upward and back to unsnap it from the dishwasher frame.
12. Adjust leveing legs
13. Remove plastic rail cover
(only on certain models)
Plastic rail cover