Installation guide

3 Connect drain hose
Connect drain hose to waste tee or waste disposer
using one ofthe following options:
* Option A, Waste disposer — no airgap
* Option -B, No waste disposer —no.air. gap
¢ Option C, Waste disposer — with air. gap
« Option D, No waste disposer — with air-gap
IMPORTANT: The drain hose connection of the disposer or a
waste tee must be made before the drain trap and at least
20" (50.8 cm) above the floor where the dishwasher will be
installed.
Helpful Tip: To reduce vibration of the hose, keep the hose away
from the floor.
1. Fit rubber end of drain hose to waste
tee and cut if needed.
NOTE: Do not cut ribbed section.
2. Attach rubber end of drain hose to
waste tee with a large blue drain
hose clamp (provided). Use pliers to
squeeze clamp open and move into
position. If the drain hose was cut,
use a 1%" to 2" (3.8 to 5 cm) screw-
type clamp (not provided).
Qa
J
.
Option C, Waste disposer - with air gap
Option A, Waste disposer — no air gap
p
Large blue
Ne drain hose clamp.
Waste disposer — no air ga
Drain hose
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Attach drain hose to disposer inlet
with large blue drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
-
-
+:
“Et.
Sy,
So
cecrew-type
©
amps
Large
blue
drain
)
:
|
hose
clamp
Rubber hose
connector
« “Disp er inlet =<
Drain hose
. [" trap
Using a hammer and screwdriver,
knock plug into disposer.
Use needle-nose pliers to remove
plug.
Connect rubber end of drain hose to
air gap and cut if needed.
NOTE: Do not cut ribbed section.
. Attach drain hose to air gap with
large blue drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
If the drain hose was cut, use a 1%"
to 2" (3.8 to 5 cm) screw-type clamp
No waste disposer — no air gap
Large
blue
drain
hose
clamp
~~.
10
(not provided).
Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from air gap to
disposer inlet.