Owners Manual

Choose Anchor Attachment Method

IMPORTANT: The dishwasher must be secured to the cabinet as

one of the final steps. Prepare the dishwasher for this by attaching

the 2 brackets found in the parts bag to the dishwasher.

– For countertops that are wood, laminate, or another similar

surface, use Countertop Attachment: go to step 36

– For countertops that are marble, granite, or another hard

surface, use Side Attachment: go to step 37

NOTE: If the gap between the top of the door and the underside of

the countertop is tight (less than 1/4" [6.35 mm]), we suggest

using Side Attachment to keep from scratching the User Interface

or console with the anchor screws.

Countertop Attachment:

36. Insert bracket

Remove the brackets from the package and insert into the

open slots on the left- and right-hand top of the dishwasher

collar as shown. Go to step 41.

Bend tab

Using pliers, bend/twist tab to lock the brackets in place.

Side Attachment:

37. Break end of bracket

Break off the end of the bracket along the scored line using

pliers.

38. Install bracket

Push bracket into slot on the side of dishwasher and bend

tab in toward the side of the dishwasher so that it keeps the

bracket in place. Repeat this step for the other side of the

dishwasher.

NOTE: Install wood shims to the inside of the cabinets if the

gap between the sides of the cabinet and the sides of the

dishwasher are greater than 1/2" (13 mm) on each side.

NOTE: Do not attach the dishwasher. This will be done later.

Final Installation Check

39. Open and close door

40. Closes too quickly – decrease spring tension

If the door closes too quickly, decrease the spring tension by

moving the spring end toward the front of the dishwasher.

NOTE: Springs should be in the same notches on left and

right sides.