Owners Manual

12
12. Adjust leveling legs
Refer to the “Dishwasher Height Adjustment Chart” for height
of leveling legs needed for your cabinet opening.
13. Remove plastic rail cover
Remove and discard the plastic rail cover on each side of the
dishwasher frame. To remove the plastic rail cover, push
upward and back to unsnap it from the dishwasher frame.
Connect Water Line to Fill Valve
– For Copper Line, begin with step 14
– For Flexible Line, begin with step 16
14. Copper water line
If using copper tubing, measure overall length of copper
tubing required to reach the water supply, cut to length, and
attach with compression fittings.
15. Slide nut and ferrule onto tubing (copper
tubing only)
Copper tubing only: Put the tubing into the 90° elbow fitting
as far as it will go. (The copper tubing bends and kinks
easily.) Slide the nut and ferrule forward and start the nut
onto the elbow threads.
NOTE: To avoid vibration during operation, route the water
supply line so that it does not touch the dishwasher base,
frame, or motor. Go to step 18.
16. Flexible line
Flexible braided line: Confirm the flexible braided line is
long enough.
17. Add 90° elbow fitting to the water supply line
Get 3/8" (9.5 mm) compression x 3/4" (19 mm) hose fitting
with 90° elbow. See the “Tools and Parts” section at the front
of the guide for part details and order. Connect the 3/8" (9.5
mm) compression fitting of the 90° elbow fitting to the water
supply line. Attach so the 3/4" (19 mm) connection is facing
upward as shown above.