Installation Instructions

DIRECT WIRE CONNECTION

Use a

/4" (6.35 mm) nut driver or

/4" (6.35 mm) hex head

socket wrench to remove the screw that holds the terminal

box to the cross brace. Then, tilt the terminal box, free the tab,

and lift the terminal box away from the crossbar.

Remove the cover by sliding it up and lifting its hooks out of

the slots. Retain cover for later use.

There should be adequate length in the wires to pull the

terminalbox out from under the dishwasher. Lift the wires

offofthe nearby clips or components to extend the length

ofwire harness for easier access.

51. Remove terminal box

52. Remove cover

53. Unclip green, white, and black wires

IMPORTANT: Check that top of door does not contact screws,

brackets, or countertop. If it does, adjust leveling legs or use

the side attachment option.

Open door and check that space between dishwasher cabinet

opening and tub is equal on both sides. If spacing is not equal,

loosen bracket screws and shift tub. Tighten bracket screws.

If side attachment method was used, reinstall the gray plastic

buttons removed in Step 39 to hide the screw holes.

48. Check door clearance

49. Check inner spacing

50. Reinstall plastic buttons

Plastic button