Installation guide

COMPLETE INSTALLATION

Check that the power supply wire or cord does not touch

dishwasher motor or the lower part of the dishwasher tub.

Plug into a grounded 3 prong outlet.

NOTE: With the access panel off, start the dishwasher and

allow it to complete the shortest wash cycle. After the rst

2 minutes, unlatch door, wait 5 seconds, then open door.

Check that there is water in the bottom of the dishwasher

tub. Check that dishwasher is working properly.

60. Power supply cord – Plug into a

grounded 3 prong outlet

61. Reconnect power

Reconnect electrical power at the fuse box or circuit

breaker box.

1. Connect rubber end of drain hose

toairgap and cut if needed.

NOTE: Do not cut ribbed section.

2. Attach drain hose to air gap with large

drain hose clamp (provided). Use pliers

to squeeze clamp open and move into

position. If the drain hose was cut, use

a 1

" to 2" (38 to 50 mm) screw-type

clamp (not provided).

3. Use a rubber hose (not provided) with

screw-type clamps (not provided) to

connect from waste tee to air gap.

Option D: No waste disposer –

withairgap

Large drain

hose clamp

Drain hose

Screw-type clamps

Air gap

Rubber hose

connector

Drain trap

Waste tee

Rubber

end