Installation guide

Helpful Tip: Remove disposer knockout plug.

1. Using a hammer and screwdriver, knock

plug into disposer.

2. Use needle-nose pliers to remove plug.

3. Attach drain hose to disposer inlet with

large drain hose clamp (provided). Use

pliers to squeeze clamp open and move

into position.

Option A: Waste disposer – no air gap

Large drain

hose clamp

Drain hose

Drain trap

Disposer inlet

CONNECT WATER LINE TO HOUSE

SHUT-OFF VALVE

NOTE: If using a exible braided hose, replace inlet hose

after 5 years to reduce the risk of hose failure. Record

hose installation or replacement dates on the hose for

futurereference.

Attach the water supply line (copper tubing or exible braided

line) to the hot water line using a connection conguration that

is in compliance with local codes and ordinances. The water

supply to the dishwasher should have a manual shut-off valve

located under the sink.

CONNECT DRAIN HOSE

IMPORTANT: The drain hose connection of the disposer

or a waste tee must be made before the drain trap and at

least 20" (508 mm) above the oor where the dishwasher

will be installed.

Helpful Tip: To reduce vibration of the hose, keep the

hoseawayfrom the oor.

58. Attach water supply line

59. Connect drain hose

Connect drain hose to waste tee or waste disposer

using one of the following options:

■ Option A: Waste disposer – no air gap

■ Option B: No waste disposer – no air gap

■ Option C: Waste disposer – with air gap

■ Option D: No waste disposer – with air gap