Service Manual

4-8

18” & 24” ADA Built-In Dishwashers

COMPONENT ACCESS

Removing the Air Breaker Assembly

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Failure to do so can result in death or

electrical shock.

Replace all parts and panels before operating.

Remove the Air Breaker Assembly

The Air breaker assembly is mounted on the le side of the

tub. Its purpose is to provide a method of supplying water for

the wash and rinse cycles. The air gap prevents the siphoning

of wash water from owing back into the water supply system

and prevents the water pressure from not dropping below

atmospheric pressure.

The Air breaker assembly also allows air into the tub for

improved drying.

To remove the air breaker assembly:

1. Unplug dishwasher or disconnect power.

2. Remove the base side panel.

3. Disconnect ow meter harness from the air breaker

assembly (see Figure 1).

Disconnect Harnesses

Figure 1

4. Open the door and from inside the cabinet, rotate the air

breaker nut and remove it from the air breaker assembly.

Pull away the air breaker assembly and remove the four (4)

clamps securing the hoses to the assembly. See Figure 2.

Remove hose clamps

Figure 2