Use and Care Manual

STEP 3

STEP 4

NOTE: For most water conditions, the factory setting will give

good results.

■ Check water hardness level to ensure no rings or spots on

your dishware before adding rinse aid or adjusting the factory

setting.

■ If you have hard water or notice rings or spots, try a higher

setting.

Turn the arrow adjuster inside the

dispenser by either using your ngers

or inserting a at-blade screwdriver into

the center of the arrow and turning.

max

fill

Select a Cycle (cycles vary by model)

See Cycle and Option Selections charts in the following section.

Heavier cycles and options affect cycle length.

Select Options (options vary by model)

See Cycle and Option Selections charts in the following section.

You can customize your cycles by pressing the options desired.

Start or Resume a Cycle

■ Run hot water at the sink nearest your dishwasher until the

water is hot. Turn off water. For best dishwashing results,

water should be 120ºF (49ºC) as it enters the dishwasher.

■ For models with controls on top of the door, select wash

cycle, options, and press START/RESUME before closing the

door. Push door rmly closed. The door latches automatically.

Select the wash cycle, options, and press START/RESUME or

press START/RESUME to repeat the same cycle and options

as in the previous wash cycle.

■ You can add an item anytime at the beginning of the cycle.

Open the door slowly and add the item. Close the door rmly.

Press START/RESUME.