Installation Instructions

ADDITIONAL TIPS

Expect longer wash times. Your new dishwasher will average

2-5 hours per load but use nearly 40% less energy than older

models. Designed with a low wattage, low energy consumption

motor, your dishwasher washes longer to ensure exceptional

cleaning. Certain models are equipped with an optical water

sensor, so the ﬁrst cycle will run longer to calibrate to optical

sensor. Selecting certain options could increase cycle time

past 3.5 hours.

Rinse Aid is necessary for good drying results:

This dishwasher is designed to be used with rinse aid for good

drying performance and controlling hard water deposit buildup.

Energy efﬁcient dishwashers use less water and energy, so

they depend on the water sheeting action of rinse aid for good

drying performance.

Start/Resume light may ﬂash:

When pressing Start/Resume, you must make sure the door

is closed within 3 seconds. If you do not close the door within

3 seconds, the Start/Resume light will ﬂash until you press it

again. (You must also do this when adding a dish during the

middle of a cycle.)

CHECK OPERATION

■ Read the dishwasher User Guide that came with

your dishwasher.

■ Check that all parts have been installed and no steps

were skipped. Check that you have all tools used.

If the dishwasher is not working properly, disconnect power

or unplug dishwasher and refer to the “If Dishwasher Does

Not Operate” section.

IF DISHWASHER DOES NOT OPERATE

First try the solutions suggested here to possibly avoid the cost

of a service call.

■ Has the circuit breaker tripped or the house fuse blown?

■ Is the door closed tightly and latched?

■ Has the cycle been set correctly to start the dishwasher?

■ Is the water turned on?

If none of these possible solutions work, please see the

User Guide for service contact information.