Installation guide

25
Metal Panel:
Place the panel against dishwasher legs. Using a Phillips
screwdriver or
1
/
4
" nut driver, reinstall the screws through
the holes in the access panel.
Check that the lower edge of the access panel touches the
floor. Adjust if necessary.
Tighten access panel screws.
63. Reinstall access panels
64. Check lower panel edge
65. Tighten screws
INSTALL ACCESS PANEL
– For Plastic, begin with Step 60
– For Metal, begin with Step 63
Plastic Panel:
Place the plastic access panel against the dishwasher leg.
Make sure insulation does not interfere with the float assembly.
Check that the lower edge of the access panel touches the
floor. Adjust if necessary.
Using a flat-blade screwdriver, turn the fasteners
1
/
4
turn
clockwise to lock into place. The fastener slot will be straight
up and down when properly locked. Go to Step 65.
60. Reinstall access panel and fasteners
Insulation
(on some models)
61. Check access panel edge
62. Tighten fasteners
1/4
turn