Manual

Assemb_iH9 tBe IIIBume_s
Check your model number. Then refer to the following for information specific to your burners.
A B A B C A B C
D E _ E ....
WCG51USOD and WCG75USOD
A. SpeedHeat TM burner
B. Standard burner
C. Standard burner
D. Accusimmer _ burner
WCG51US6D
A. Standard burner
B. SpeedHeat TM burner
C. Accusimmer _ burner
D. Standard burner
E. Standard burner
Burner Head Placement
• Burner caps and heads are included with your cooktop.
• Always match the burner head size to the cap size.
• Always line up the hole in the burner head to the electrode.
• The cooktop comes with an extra Melt cap on WCG9 series
models. This is a large cap with "MELT" and "FOR SMALLEST
BURNER" printed on it. Use this cap over the smallest burner only.
• Standard, SpeedHeat TM and FlexHeat TM burners are similar in
assembly. Note that there is no hole in the FlexHeat TM dual flame
burner head to insert the electrode. The FlexHeat TM burner
electrode (C) aligns with the semicircle notch in the head (B).
WCG9
A. Standard burner
B. FlexHeat TM burner
C. Accusimmer _ Plus burner
D. Standard burner
E. Standard burner
Grate IIP aoeme
To install the grates, align the feet on the center grate with the indents
on the cooktop. Then install the 2 outer grates by aligning the tabs on
the center grate with the slots in the outer grates. Be sure to line up the
slots and tabs for proper grate alignment.
C
A
B
C ................................. //
Standard and FlexHeat TM Burner
SpeedHeat TM Burners A. Cap
A. Cap B. Head
B. Head C. Electrode
C. Electrode
A. Outer grate slot
B. Center grate tab