Instruction for Use

38
Water stop anti-flooding
system
(depending on model)
•
Screw the hose to the water
supply tap. Turn the tap fully
on and check the water-
tightness of the connection.
•
The washing machine must
not be connected to the
mixing tap of a non-
pressurized water heater!
•
The inlet hose and the plastic
enclosure contain
(depending on model)
electrical components: do
not cut the hose and do not
immerse the enclosure in
water.
•
If the flexible hose is
damaged, unplug the
washing machine from the
mains immediately, turn off
the tap and replace the
hose.
If the flexible hose is too short,
replace it with a 3 m Water
Stop hose (available from
After-Sales Service or from
your dealer). This operation
must be carried out exclusively
by a qualified technician.
Connect the water drain
hose
1.
Unhook the drain hose from
the left and right hose
connections, see arrow
A
in
figure.
Minimum drain height: 55 cm.
If you fix the drain hose to a
drainage stand pipe, the
internal diameter of the drain
pipe should be 3 cm minimum.
To avoid a syphon effect, the
end of the drain hose should be
55 cm min. from the floor.
Important:
Do NOT loosen the drain
hose connection from the
left side, see arrow B in
figure
.
Otherwise, there is the
risk of leakage and of scalding
with hot water.
2.
Fix the “U” bend (
C
) to the
free end of the drain hose.
3.
Connect the drain hose to
the siphon or hook it over
the edge of a sink with the
“U” bend.
Small hand basins are not
suitable.
The edge of the sink must be
no more than 100 cm from
the floor.
If you need to add an
extension, use a flexible hose
of the same size and secure the
unions with screw-on hose
clips.
Maximum overall drain hose
length: 2.50 m.
Maximum drain height
(“U” bend): 100 cm.
Minimum drain height: 55 cm.
Important:
Make sure there are no kinks in
the drain hose and take
precautions against it falling
while the washing machine is
running.
A
B
C