Instruction for Use

28
Indicates the current programme step.
The indicator moves from left to right after the
programme start through “Wash”, “Rinse” and
“Spin”. At the end of the programme the indicator
returns to its initial position on the left side.
DOOR LOCK
When you start the programme the door is
automatically locked until the programme
terminates.
“Door closed” indicator lights up.
Exception:
When running the “Cotton” and “Easy
care/Synthetics” programmes (without prewash)
the door can be opened for adding further laundry
during the first 15 minutes. If “Short/Rapid” (Quick
wash) has been selected, however, this is not
possible.
If the programme selector knob is turned to the “0”
position or the power supply is interrupted, the door
unlocks automatically after about 2 minutes.
PROGRAMME END
1.
Programme end is indicated by the fact that
-
the programme sequence indicator is no
longer visible.
-
the “Door closed” indicator is switched off.
2.
Cancel the selected special functions by
pressing the appropriate button again.
3.
Set the programme selector on "0".
The pilot lamp switches off.
4.
Open the door and remove the load.
5.
Turn off the tap(s).
Note:
Leave the door ajar so that the drum can dry.
PROGRAMME RESELECTION
a.
CONTINUING WITH A NEW PROGRAMME
OR TEMPERATURE SETTING
1. Select the new programme or
temperature setting.
2. Hold down the “Start” button for about
one second.
The new programme continues with the
same programme step at which the previous
programme was interrupted.
b.
CANCELLING THE CURRENT PROGRAMME
AND RESTARTING WITH A NEW ONE
Do not put more detergent into the machine for
the new programme, since almost no water is
drained out when a programme is cancelled.
1. Hold down the “Start” button for 5 seconds,
or until the programme control audibly
restarts.
2. Wait until the programme sequence
indicator has returned to its initial (leftmost)
position and has disappeared.
3. Set the programme selector to “0”.
4. Select the new programme, temperature
and any special options desired.
5. Hold down the “Start” button for one second.
TO INTERRUPT/PAUSE A PROGRAMME
To interrupt the current programme for a certain
time and resume it later:
1.
Set the programme selector to “0”.
2.
After the desired time, reselect the programme.
3.
Hold down the “Start” button for about one
second.
The programme continues.
TO STOP A PROGRAMME BEFORE THE
END AND DRAIN
To stop a programme before the end and drain
the water:
1.
Set the programme selector to "Drain".
2.
Hold down the “Start” button for about one
second.
The machine drains.
Only open the door when the programme
sequence indicator has returned to its initial
(leftmost) position and the “Door Closed”
indicator is off.
PROGRAMME SEQUENCE INDICATOR
DOOR LOCK / PROGRAMME END
PROGRAMME RESELECTION / INTERRUPTION