Instruction for Use

70
INSTALLATION
•
Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
•
Make sure that all four feet are stable and resting
on the floor and then check that the appliance is
perfectly level (use a spirit level).
•
If the floor is uneven, adjust the levelling feet as
required (do not insert pieces of wood etc. under
the feet):
1.
Slacken the locknut using the wrench supplied.
2.
Adjust the height of the foot, turning it by hand.
3.
Tighten the locknut by turning it anti-clockwise
towards the appliance casing.
•
If the appliance is to be installed on a wooden floor,
distribute the weight by placing it on a 60 x 60 cm
sheet of plywood at least 3 cm in thickness.
Secure the plywood sheet to the floor.
WORKTOP / COVER PANEL
The appliance must only be installed beneath a
continuous fitted kitchen worktop.
If the appliance will be built under it is mandatory
to use the cover panel UBS. This can be obtained
from specialist shops or from After-Sales Service.
•
Unplug the appliance.
1.
Unscrew the worktop fixing screws from the rear of
the appliance.
2.
Slide the worktop fully backward and lift it upwards
to remove. Install the cover panel following the
relative instructions.
3.
Refit the fixing screws and tighten them.
BUILD-UNDER OPENING DIMENSIONS
Width 600 mm
Height 825 mm
Depth 600 mm
WARNING:
Only plug the appliance into the mains power socket
after you have fitted the cover panel or the appliance
worktop.
INSTALLATION INSTRUCTIONS