Instruction for Use

6
INSTALLATION
•
Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
•
Make sure that all four feet are resting firmly
on the floor and check that the appliance is
perfectly level (use a spirit level).
•
If the floor is uneven, adjust the levelling feet
as required (do not insert pieces of wood,
cardboard etc. under the feet).
Slacken the locknut using the spanner
supplied.
Adjust the height of the foot, turning it by
hand.
Tighten the locknut anticlockwise towards
the washing machine.
•
If the appliance is to be installed on a wooden
floor, distribute the weight by placing it on a
60x60 cm sheet of plywood at least 3 cm in
thickness. Secure the plywood sheet to the
floor.
BUILD-UNDER / WORKTOP
The appliance must be installed only under a
fitted, continuous kitchen worktop.
The appliance must only be built under using
the built under set UBS.
•
Unplug the appliance from the mains.
Unscrew the worktop fixing screws (2 or 3
screws depending on the model) from the
rear of the appliance.
Slide the worktop fully backward and lift it
upwards to remove.
Install the cover panel following the relative
instructions.
Refit the fixing screws and tighten them.
BUILD-UNDER OPENING DIMENSIONS
Width 600 mm
Height 825 mm
Depth 600 mm
WARNING:
Only plug the machine into the mains power
socket after you have fitted the cover panel or the
machine worktop.
INSTALLATION INSTRUCTIONS
1.
2.
3.
1.
2.
3.
3
1
2
1
2
3