Installation guide

INSTALLATION INSTRUCTIONS
4. Attach brackets to cooktop base bottom with bracket
attachment screws. Securely tighten screws.
T pte, grcbirgpeng lh PP gree, ght | pe tor, api
insiall Cookiop
AWARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury. Brrr
Decide on the final location for the cooktop. Avoid drilling into or
severing existing wiring during installation.
1. Determine whether your cabinet construction provides
clearance for installing clamping brackets at cooktop base
ends. This is the recommended location. Clamping brackets
can be installed on the front and back of cooktop base
bottom, if necessary.
A. Cooktop
B. Cooktop base
C. 2" (5.1 cm) bracket attachment screw
D. Clamping bracket (extends far enough beyond cooktop
base to allow installation of clamping screws)
E. Countertop
NOTE: There will be a small gap (approximately Ye" [3 mm])
between the cooktop and the countertop. This is normal. See
the following illustration.
Ze
A. Attachment screw holes for optional front and back location
B. Cooktop base bottom
C. Attachment screw
D. Clamping bracket (end locations recommended)
2. Using 2 or more people, place cooktop right side up into the
cutout.
NOTE: Make sure that the front edge of the cooktop is
parallel to the front edge of the countertop. If repositioning is
needed, lift entire cooktop up from cutout to avoid scratching
the countertop.
3. Remove the attachment screws for the selected bracket
locations from the bottom of the cooktop base.
i 4 A. Small gap (approximately 18" [3 mm])
A between cooktop and countertop
<!
A. Edge of cooktop base bottom
B. Clamping bracket