Instruction for Use

20
GB
Programming the cooking time
! All the cooking zones may be programmed for a
length of time between 1 and 99 minutes.
1. Switch the hotplate on and set the temperature.
2. Press the button repeatedly until the light
corresponding to the plate you wish to use illuminates.
3. Set the cooking time using the
and
buttons.
4. Confirm by pressing the
button.
The timer begins counting down immediately. When
the set programme has finished, a buzzer sounds for
about 10 seconds and the cooking zone switches off.
Repeat the above procedure for each hotplate you
wish to programme.
Using multiple programmes and the display
If one or more plates are programmed, the display will
show the data for the plate with the least time
remaining, and the light corresponding to the position
of the plate will be switched on. The lights
corresponding to the other plates programmed will
flash.
To display the time remaining for the other
programmed plates, press the
button repeatedly.
The times remaining for each plate will be shown in a
clockwise order, beginning with the front left plate.
Changing the programme
1. Press the
button repeatedly until the time you
wish to change is shown.
2. Use the
buttons to set the new time.
3. Confirm by pressing the
button.
To cancel a programme, follow the above points.
When it comes to point 2, press the
buttons
simultaneously. The setting will return to zero and the
display will no longer be operating in the programme
set function.
Control panel lock
When the hob is switched on, it is possible to lock the
oven controls to avoid accidental changes to the
settings (by children, during cleaning, etc.). Press the
button to lock the control panel: the indicator light
above the button will switch on.
To use any of the controls (e.g. to stop cooking), you
must switch off this function. Press the
button for a
few moments, the indicator light will switch off and the
lock function will be removed.
Switching off the hob
Press the
button to switch the appliance off.
If the control panel lock is on, the controls will
continue to be locked even after the hob is switched
on again. In order to switch the hob on again, you
must first remove the lock function.
Demo mode
It is possible to set the hob to a demonstration mode
where all the controls work normally but the heating
elements do not switch on. To activate the demo
mode the hob must be switched on, with the control
panel lock activated.
 Press the
button for the rear left plate, the
button for the front right plate and the button
simultaneously and hold them for three seconds.
 The display will alternate between DE and MO and
the hob will be switched off.
 When the hob is switched on again it will be set to
the demo mode.
To cancel this function:
 When the hob is switched on and the control panel
lock is on, press the buttons as instructed above.
 The display will alternate between RE and AL and
the hob will be switched off.
 When it is next switched on, the hob will function
normally.