Instruction for Use

20
GB
Switching the appliance off
During cleaning and maintenance it is necessary to
disconnect the appliance from the electricity supply:
1. Hold the ON/OFF button down for more than two
seconds until OFF appears on both indicator displays
(refrigerator and freezer).
2. Pull the plug out of the socket.
! If this procedure is not followed, the alarm may sound.
This alarm does not indicate a malfunction. To restore
normal operation, hold the ON/OFF button down for
more than two seconds. To disconnect the appliance,
follow points 1 and 2 above.
Cleaning the appliance
 The external and internal parts and the rubber seals
may be cleaned using a sponge that has been
soaked in lukewarm water and bicarbonate of soda or
neutral soap. Do not use solvents, abrasive products,
bleach or ammonia.
 The removable accessories may be soaked in warm
soapy water or dishwashing liquid. Rinse and dry
them carefully.
 The back of the appliance may collect dust. This can
be removed by carefully using the hose of a vacuum
cleaner set on medium power. The appliance must be
switched off and the plug disconnected from the
electricity mains before it is cleaned.
Avoiding mould and unpleasant odours
 The appliance is manufactured with hygienic, odour
free materials. Food should be wrapped well and
containers closed properly in order to maintain this
hygiene. This will also prevent the formation of stains.
 If you wish to switch the appliance off for an extended
period of time, clean the inside and leave the doors
open.
Maintenance and care
Replacing the light bulb
To replace the light bulb
in the refrigerator
compartment, pull out the
plug from the electrical
socket. Follow the
instructions below.
Access the light bulb by
removing the cover as
indicated in the diagram.
Replace it with a similar
light bulb within the
power range indicated on the cover (10W).
To replace the light bulb
in the freezer
compartment, pull out the
plug from the electrical
socket. Follow the
instructions below.
Access the light bulb (A)
by unscrewing the fixing
screw (B) which is
located at the back of the
lampcover, as shown
(see diagram). Replace it
with a similar light bulb within the power range indicated
on the cover (10W or 15W).
A
B