DISHWASHER SUD4000 Use & Care Guide

ManualsBrandsWhirlpool ManualsDishwasherSUD4000

Storing Your Dishwasher

Storing for the summer

Protect your dishwasher during the summer months by

turning off the water supply and power supply to the

dishwasher.

Moving or winterizing your dishwasher

Protect your dishwasher and home against water damage

due to freezing water lines. If your dishwasher is left in a

seasonal dwelling or could be exposed to near freezing

temperatures, have a qualified person do the following:

1. Disconnect power supply to the dishwasher.

2. Turn off water supply to the dishwasher.

3. Remove the 4 screws on the lower access panel.

Remove the lower access panel.

4. Place a shallow pan under the water supply valve.

Then, use a wrench to disconnect the water inlet from

the water supply valve. Separate the water inlet from

the water supply valve and drain water into the pan.

1. Water outlet

2. Spring clamp

3. Screw clamp

4. Water pump and motor

5. Water supply valve

6. Water inlet

7. Drain hose

5. Remove the spring clamp from the water outlet and

separate from the water supply valve; drain water into

pan.

6. Reconnect both water inlet and water outlet to the

water supply valve.

7. Empty the pan and reposition it under the water pump.

8. Remove the clamp and disconnect the drain hose from

the water pump; drain water into pan.

9. Reconnect drain hose to the water pump, being sure

to position the clamp over the connection.

10.Replace the lower access panel.

NOTE: If your dishwasher is connected to a garbage

disposal, do not run water into the sink after winterizing.

This could cause water to refill the drain hose on your

dishwasher.

Reconnecting your dishwasher

1. Remove the 4 screws on the lower access panel and

remove lower access panel.

2. Turn on the water supply to dishwasher.

3. Turn on power supply to dishwasher.

4. Run dishwasher through a complete cycle and check

for leaks.

5. Replace lower access panel.

3. 4.