Instruction for Use

ManualsBrandsWhirlpool ManualsDomestic AppliancesSR11PSWAX

WARNING – THIS APPLIANCE MUST BE EARTHED.WARNING – THIS APPLIANCE MUST BE EARTHED.

WARNING – THIS APPLIANCE MUST BE EARTHED.

Electrical connectionElectrical connection

Electrical connection

Electric cookers come without a power supply cable. The cooker is

designed to operate on an electricity supply which conforms to the electrical

data shown on the Rating Plate. The cooker can be connected to the mains

only after removing the back panel of the cooker itself with a screwdriver.

N.B.:N.B.:

N.B.: the following installation procedure must be carried out by a qualified

electrician. The electrical installation must comply with the IEE Regulations,

Building & local By-Lays.

For the installation of the power cable carry out the following operations:

• Using a screwdriver, prise on the side tabs of the terminal board

cover (see fig. A);

• Pull and open the junction blok lid

Important:Important:

Important: the wires in the mains lead are coloured in accordance with the

following code:

Green & Yellow

EarthEarth

Earth

Blue

NeutralNeutral

Neutral

Brown

LiveLive

Live

As the colours of the wires in the mains lead may not correspond with the

coloured markings identifying the terminals in your plug, proceed as follows:

Green & Yellow wire to terminal marked “

E” or

or coloured Green or

Green & Yellow.

Brown wire to terminal marked “

L” or coloured Red.

Blue wire to terminal marked “

N” or coloured Black (see fig. B).

• fix the power cable in the special cable stop and close the cover.

N.B.:N.B.:

N.B.: the power supply cable must have these minimum requirements:

Type: H05RR-F

Section: 3x4 mm

Ensure that the mains cable is routed away from any brackets affixed to the

rear panel and is not trapped to the rear wall when pushing the cooker into

position between cabinets.

The appliance is designed to work with alternating current at the supply voltage and frequency indicated on the

rating plate (situated on the rear part of the appliance and on the last page of the instruction booklet) or at the end

of the instruction booklet. Make sure that the local supply voltage corresponds to the voltage indicated on the

rating plate.

To connect directly to the mains supply, a double-pole switch with a contact separation of at least 3 mm suitable

for the load and complying with current standards and regulations, must be fitted between the appliance and the

mains supply outlet. The yellow-green earth wire must not be interrupted by the switch. The supply cable must be

in such a position that no part of it can reach a temperature of 50 °C above room temperature. Before making the

connection, check that:

• The limiter valve and the home system can support the appliance load (see data plate);

• The mains are properly earthed in compliance with current standards and regulations;

• There is easy access to the socket and omnipolar circuit breaker, once the hob has been installed.

N.B.:N.B.:

N.B.: never use reducers, adaptors or shunts since they can cause heating or burning.

Fig. A

Fig. B