Installation guide

9. Grasptheedgesoftheovendoorwithbothhandsandclose
theovendooruntilitwillnolongerclose.Liftandpulloven
doortowardyouandremove.Settheovendoorasideona
protectivesurface.
10.Sidetrimsarelocatedonthesideoftheunit.Sidetrimsmust
beremovedbeforeunitisinstalledinthecabinet.Removethe
cabletiesfromthesideoftheunit.
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge solid copper wire.
Electrically ground oven,
Failure to follow these instructions can result in death,
fire, or electrical shock.
This oven is manufactured with a neutral (white) power supply
wire and a cabinet-connected green (or bare) ground wire twisted
together.
1. Disconnect power.
2. Feed the flexible cable conduit from the oven through the
opening in the cabinet.
3. Remove junction box cover if it is present.
4. Install a UL listed or CSA approved conduit connector to the
junction box.
A. UL listed or CSA approved conduit connector
5. Route the flexible cable conduit from the oven to the junction
box through a UL listed or CSA approved conduit connector.
6. Tighten screws on conduit connector.
7. See "Electrical Connection Options Chart" to complete
installation for your type of electrical connection.
Eleckical Connection Options Chart
If your home has: Go to section:
4-wire 4-wire Cable from Home
_rn Power Supply
)
3-wire 3-wire Cable from Home
Power Supply
1/2"
)
4-Wire Cable from Home Power Supply
IMPORTANT: Use the 4-wire cable from home power supply in
the U.B. where local codes do not allow grounding through
neutral, New Branch circuit installations (1996 NEC), mobile
homes and recreational vehicles, new construction and in
Canada.
C
D
\ ............. H
A. Cable from home power supply
B. Black wires
C. Red wires
D. 4-wire flexible cable from oven
E. Junction box
E White wires
G. UL listed wire connectors
H. Green (or bare) ground wires
L UL listed or CSA approved
conduit connector
1,
2.
3.
4.
5.
Connect the 2 black wires (B) together using a UL listed wire
connector.
Connect the 2 red wires (C) together using a UL listed wire
connector.
Untwist white wire from green (or bare) ground wire coming
from the oven.
Connect the 2 white wires (F) together using a UL listed wire
connector:
Connect the green (or bare) ground wire (H) from the oven
cable to the green (or bare) ground wire (in the junction box)
using a UL listed wire connector.
6. Install junction box cover.
6