Service manual
Indication
1:
None of the indicators or dis- ACTIVATING THE CONSOLE AND
play turns on.
INDICATORS DIAGNOSTIC TEST MODE
Action:
Press POWER button to enter setting
This test checks the cycle selector knob, indi-
mode.
cators, buttons, two-digit display and beeper.
If indicators come on, try to change the
function for the button used to activate
the diagnostic test mode. If that button
fails to change the function, something
is faulty with the button, and it is not
possible to enter the diagnostic mode.
If no indicators come on afler pressing
POWER button, go to TEST
#I.
lndication
2:
Fault code flashes from the
display.
Action:
Review the Display FaultIError Codes
table for the recommended procedure.
DIAGNOSTIC: Saved Fault Codes
If there are saved fault codes (as indicated in
step
3
of Activating the Automatic Diagnostic
Test Mode), the most recent fault code will be
displayed and alternately show "F" and
"XX"
where XX is the fault code, and all the cycle
selector indicators flash.
1.
Plug in washer or reconnect power.
2.
Read through step
3
before continuing.
From Standby
(Off) Mode press and re-
lease (key-dance) the following buttons
within
4
seconds:
If successful, two-digit
dt
will display and
you will have
5
seconds to complete next
step.
3.
Within
5
seconds of
dt
showing in display,
press START (all indicators in display are
illuminated and
88
is displayed).
Press START a second time. This
turns off status indicators and two-digit
display (all other indicators remain il-
luminated).
.'
Press START a third time. This turns
on status indicators and two-digit dis-
play (all indicators are illuminated).
4.
Rotate WASH CYCLE selector back and
forth. lndicators will toggle on (or off).
5.
Press buttons to verify function. Indica-
tors will toggle on (or off) and beep tone
will sound when buttons are pressed.
NOTE:
Pressing SOIL LEVEL, SPIN
SPEED and WASHIRINSE TEMP will
cause all indicators above these buttons
to toggle on (or off) at one time.
If any of the following occur during steps
above, see TEST
#4:
None of the indicators light up
.
No beep sound is heard
Some buttons do not light indicators
DEACTIVATING THE DIAGNOSTIC
TEST MODE
Press the STOP or POWER button at any
time to exit Manual, Automatic or Console
&
lndicators diagnostic test modes.