Installation guide

5. Cut the 11/2"(3.8 cm) diameter hole at the circular shaded area

"G" on the template. This hole is for the power supply cord.

NOTE: If upper cabinet is metal, the supply cord bushing needs to

be installed around the supply cord hole, as shown.

A. Metal cabinet

B. Power supply cord bushing

6. Drill 3/8" (10 mm) holes at points "D" and "E" on the template.

These are for two 1/4-20 x 3" round-head bolts and washers

used to secure the microwave oven to the upper cabinet.

For Roof Venting Installation Only

7. Cut 3/4" (19 mm) hole at one corner of the shaded rectangular

area "F" on Upper Cabinet Template.

8. Using a keyhole saw, cut out the rectangular area.

1. Check that damper blade moves freely, and opens fully.

2. Position the damper assembly on the back of the microwave

oven so that the damper blade opens away from the

microwave oven.

A. Back of microwave oven

B. Damper assembly

C. Damper blade

D. Sheet metal screws

3. Secure damper assembly with 2 sheet metal screws.

ns xs the Mc Oven

Excessive Weight Hazard

Use two or more people to move and install

microwave oven.

Failure to do so can result in back or other injury.

IMPORTANT: The control side of the unit is the heavy side.

Handle the microwave oven gently.

1. Place a washer on each 1/4-20 x 3" flat-head bolt and place

inside upper cabinet near the 3/8" (10 mm) holes.

2. Make sure the microwave oven door is closed and taped shut.

3. Using 2 or more people, lift microwave oven and hang it on

support tabs at the bottom of mounting plate.

NOTE: Do not grip or use the door or door handle during

installation.

A. Mounting plate

B. Support tabs

With front of microwave oven still tilted, thread power supply

cord through the power supply cord hole in the bottom of the

upper cabinet.

5. Rotate microwave oven up toward upper cabinet.

NOTE: If venting through the wall, make sure the damper

assembly fits easily into the vent tube in the wall cutout.