Instruction for Use

20 ARISTON DISHWASHER - Instructions for installation and use
D
ISHWASHER
Safety within your home
Your dishwasher was built in accordance with the strictest international safety regulations. They protect
you and your family. Read the instructions and information contained in this manual: they will provide
you with useful hints as to installation, use and maintenance safety. To avoid nasty surprises.
1. Dispose of the packaging
material carefully (follow the
instructions on how to divide
your rubbish up provided by
your local Council)
2. After removing the packaging,
check to make sure your
appliance is intact. If in doubt,
contact a qualified
professional.
3. Your dishwasher must only be
used by adults and for washing
household dishes, according to
the instructions included in
this manual. Do not touch the
appliance with wet hands or
feet or barefoot.
4. We discourage the use of
extension leads and multiple
plugs. If the electricity supply
wire is not long enough, then
have it replaced with one of
the correct length and
remember that it should be
free of bends or dangerous
kinks.
5. If the appliance is not operating
properly or if maintenance
operations are necessary,
disconnect the dishwasher
from the mains power supply
(unplug it!).
6. Keep children away from the
dishwasher when it is open and
keep detergents out of their
reach.
7. Your dishwasher is not to be
installed outdoors, not even if
the area is covered by a roof:
it is extremely dangerous to
leave it exposed to rain and
thunderstorms.
8. Do not touch the heating
element during or straight after
a wash cycle.
9. Do not lean or sit on the door
when it is open, as this could
overturn the dishwasher.
10. If the appliance malfunctions,
turn off the water inlet tap and
disconnect the plug from the
wall socket. Then try
consulting the section entitled
"I you have a problem, read
this". If you cannot resolve the
problem, then call the service
centre.
If you have a problem, read this
Your dishwasher may not work or not function properly. In many cases, these are problems which can be
solved without having to call for a technician. Before calling the service centre, always check the points
below.
The dishwasher won't start
■ Is the water supply tap turned
on?
■ Is the water supply tap
connected to the hose properly?
■ Has the water in your home
been cut off?
■ Is the pressure of the water
supply sufficient?
■ Is the hose bent?
■ Is the filter on the water supply
hose blocked?
■ Is the dishwasher door open?
The dishes are not clean.
■ Have you put the right amount
of detergent into the dispenser?
■ Is the wash cycle suitable for
the dishes you have placed
inside the appliance?
■ Are the filter and microfilter
clean?
■ Can the sprayer arms turn
freely?
The dishwasher won't
drain.
■ Is the drain hose bent?
Limescale deposits or a
white film form on the
dishes.
■ Is the lid on the salt container
closed properly?
■ Is the rinse aid dosage correct?
Error messages.
Your dishwasher is equipped with
a safety system which is able to
detect any operating anomalies.
These anomalies or faults are
signalled by several codes
consisting of letters and numbers
that flash up on the display.
Make a note of the error code that
appears, turn the appliance off, turn
off the water tap and call for
technical assistance.
Tap off alarm
If you have forgotten to turn on the
water tap, the appliance will
remind you with a series of
prolonged beeps and the wording
H2O will flash up on the display.
Turn the tap on and the wash cycle
will start up after a few minutes.
If you are not there when the H2O
signal appears, the appliance will
switch to alarm mode and the code
"A06" will flash on the display.
Turn the appliance off at button "A",
turn on the water tap and wait
approximately 20 seconds before
turning the appliance back on, the
wash cycle will start up again.
Clogged filter alarm
If the appliance is blocked and the
code "A05" is flashing, this means
the filter is clogged by large
particles of food residue. Turn the
appliance off at the ON-OFF
button, clean the filter thoroughly
and reposition it in its seat, then
turn the appliance back on. The
wash cycle will start up as normal
after a few seconds.
Troubleshooting
11. Once taken out of use,
appliances must be made
inoperable: cut the power
supply wire and damage the
door lock.
I only want an authorised
specialised technician with original
Ariston guaranteed spare parts
Never call upon
the services of
unauthorised
technicians and
always refuse
spare parts that
are not originals.
You have checked
everything, but the
dishwasher still doesn't
work and the problem
persists?
Call an authorised service centre
near you and remember to mention:
 the type of malfunction
 the model mark (Mod.) and the
serial number (S/N.) indicated on
the rating plate located on the inner
door, to one side.
Water load solenoid valve
malfunction alarm
If the code "A02" flashes,TURN the
dishwasher OFF AND BACK ON
AGAIN after one minute. If the
alarm persists, first turn off the
water tap to avoid any flooding and
then cut off the electricity supply
and call for technical assistance.