Instruction for Use

Failure indicator
lights up
Indication on display
(if available)
Description - Causes - Solutions
“Service”
“bdd”
(incaseyourwashing
machinehasno
display:alllampsofthe
programmeflowbar
lightup)
from“F02”to“F35”
(except“F09”)
“F09”
“ FA”
“Fod”
Appliancestopsduringtheprogramme.
“Drumflapsopen”(thedrumflapshavenotbeen
closedproperly).
Pushthe“Reset”buttonforatleast3secondsand
waituntilthe“Dooropen” lightsup.
Openlidandclosedrumflaps,thenselectand
startdesiredprogrammeagain.Iffaultpersists,
notifyourAfter-SalesService.
“Electricalmodulefault”
Selectandstart“Drain”programmeorpush
“Reset”buttonforatleast3seconds.
“Waterleveltoohigh”(afterprogramme
cancellationorfalseoperating).
Switchoffapplianceandthenswitchitonagain,
selectprogramme“Drain”andstartwithin15sec.
“Waterstopfault”
Switchoffappliance,pulloutmainsplugandturn
watertapoff.Tiltapplianceforwardcarefullyto
allowcollectedwatertoflowoutfromthe
bottom.
Then:
• Plugintheapplianceagain.
• Turnthewatertapon(ifwaterimmediately
flowsintotheappliancewithouttheappliance
beingstarted,thereisafailure;turnoffthetap
andnotifyAfter-SalesService).
• Selectandstartthedesiredprogrammeagain.
“Overfoaming”
Toomuchfoaminterruptedthewashprogramme.
• Selectandstart“Rinse&Spin”programme.
• Afterwardsselectandstartdesiredprogramme
again,usinglessdetergent.
Iffaultspersist,unplugtheappliance,turnoffthe
watertapandcontactourAfter-SalesService(see
nextchapter).
GB14
Description of failure indicators