User Guide

Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.]
l Push Control Knob in.
l Turn clockwise to any* on the dial.
See above drawing.
l Pull Control Knob out.
l The washer will fill to selected level
with cold water,agitate 2 minutes,
drain and spin.
For a drain and spin
Your washer can be set to drain
and spin out water.
l Push Control Knob in.
l Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l Pull Control Knob out.
l The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 6 and 7.
For a soak or pre-wash
l Use enough detergent or pre-soak
For best results, use warm water
product for a single load.
for soaking or pre-washing stained
l Push Control Knob in.
laundry.
l Turn clockwise to point at a number
in the SOAK Cycle...use the 12-
minute mark for a pre-wash.
l Pull Control Knob out.
l When the cycle is over, add de-
tergent for the next selected wash
cycle. Important: See additional
care information on page 7 of your
“laundry Guide.”
l Set the washer and start the next
selected wash cycle.
To start the soak or pre-wash with agitation, the Cycle Control
Knob must point to a number in the SOAK Cycle.
Cleaning the lint filter
Water runs through the lint filter
whenever the washer agitates.
Check it often to make sure it’s clean
and is filtering at its best.
To remove it for cleaning, press the
release and pull straight out. Instruc-
tions for cleaning are printed on the
bottom of the filter.
8