AUTOMATIC WASHERS Use & Care Guide

Operating Instructions

The drawings in this book may vary slightly from your washer model. They are

designed to show the different features of all the models covered by this book.

NOTE: Your model may not include all the features shown.

Starting your washer

Be sure to measure and add detergent, then place a sorted load in the washer before

starting it.

1. Select a load size

Turn the knob to point at a setting that

describes the size of load you want

to wash.

Set the knob anywhere on or between

EX SMALL (a few small items) and

EX LARGE (a full load).

To change the water level after the

washer has started to fill, turn the

knob to RESET, then to the desired

water level.

NOTE: For best washing results, items

should move freely in the washer. Do

not overload the washer or choose a

water level that is too low for your wash

load.

For best results with permanent

press clothes, use the EX LARGE water

level.

Reduce wash time when using EX

SMALL or SMALL water level settings.

Loads with only a few small items need

less wash time for best results.

2. Select water temperature

Match the water temperature to the

type of fabric and soils being washed.

The top temperature is the wash

selection and the bottom temperature

is the rinse selection.

NOTE: Use warm wash water with

the PERMANENT PRESS or KNITS

GENTLE Cycles.

For heavily soiled permanent press

or knit clothes, pre-wash or pre-soak

before washing in warm water.

ALWAYS use cold rinse water for

permanent press fabrics.