Instruction for Use

Note: see the description sheet for the model.

1. Remove the pan support (A).

2. Remove the burners (B).

3. Unscrew the injector (C) with a box spanner 7.

4. Replace the injector with the one for the new gas.

Note: before installing the hob, remember to attach the gas

calibration label provided with the replacement injectors so that it

covers the information already present.

Replacing the injectors

If you are using a different kind of gas from the one

indicated on the serial no. plate and the orange

label on the back of the hob, you must replace the

injectors; in the case of the Wok burner, adjust the

primary air (see Injector table on page 7).

The orange label should be removed and kept

together with the manual.

Use pressure regulators suitable for the gas

pressures indicated on page 7

• In order to replace the injectors, contact the

Customer Care Centre on 00800-3810-4026,

or a qualified electrician.

• Injectors not supplied as standard should be

requested from the Customer Care Centre on

00800-3810-4026.

• Regulate the minimum levels of the taps.

Note: with liquid petroleum gas ( G30/G31)

the bypass screw must be screwed in fully. If

you then experiance difficulty in turning the

control knob, contact our After sales Service

though our Customer Care Centre on

00800-3810-4026, who will arrange for a

replacement after ascertaining that the tap is

damaged.

Adaption to a different type of gas supply

Regulating the minimum flow level must be done with the tap at the

lowest position (small flame) .

There is no need to regulate the primary air in the burners.

To ensure the minimum level is properly regulated, remove the control

knob and adjust the screws found on the tap as follows:

1. tighten to reduce the height of the flame 1 (-)

2. slacken to increase the height of the flame (+);

3. With the burners on, rotate the buttons from the maximum to

the minimum position to check the stability of the flame.

Once you have finished regulating, close up the seals again using sealing

wax.

Regulating the minimum flow level of the gas taps