Health & Safety and Installation guide
EN ENGLISH Health and Safety guide Installation guide 2 3 8
SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED Before using the appliance read these safety instructions. Keep them nearby for future reference. These instructions are valid if the country symbol appears on the appliance. If the symbol doesn’t appear on the appliance, it is necessary to refer to the technical instructions which will provide the necessary instructions concerning modification of the appliance to the conditions of use of the country.
The air circulation system may take air directly from the outside by means of a pipe with an inner cross section of at least 100 cm2; the opening must not be vulnerable to any type of blockages. The system can also provide the air needed for combustion indirectly, i.e. from adjacent rooms fitted with air circulation tubes as described above. However, these rooms must not be communal rooms, bedrooms or rooms that may present a fire hazard. Liquid petroleum gas sinks to the floor as it is heavier than air.
3. Unscrew the burner fastening screws. 4. Remove screw “V” and then the oven burner. V 5. Unscrew the oven burner nozzle using the special socket spanner for the nozzles, or better still a 7 mm socket spanner, and replace it with a nozzle suited to the new type of gas (see Table 1). 6. Replace all the parts, following the steps described above in the reverse order. Take care to replace also the bottomof the oven in its original position.
equipment or pressure cleaners on the appliance. WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock. Do not use harsh abrasive cleaners or sharp metal scrapers to clean the appliance door glass since they can scratch the surface, which may result in shattering of the glass. Wear protective gloves for cleaning and maintenance. The appliance must be disconnected from the power supply before any maintenance operation.
EN SAFEGUARDING THE ENVIRONMENT DISPOSAL OF PACKAGING MATERIALS The packaging material is 100% recyclable and is marked with the recycle symbol . The various parts of the packaging must therefore be disposed of responsibility and in full compliance with local authority regulations governing waste disposal.
x2 90°C 8
EN 20 423 557 97 478 595 89° max 525 570 5 4 595 549 min 560 min 560 560 600 45 560 583+2 45 5 9
= = x2 4 0 0 0 1113 2 4 9 7 Printed in Italy 10