Instruction for Use

EN17
SETTINGS
1. To change some display settings, select “SETTINGS” from the main menu by turning the “Functions” knob.
2. Confirm with button : the display shows which settings can be changed (language, volume of
acoustic signal, display brightness, time, energy saving function).
3. Select the setting to be changed by turning the “Browse” knob.
4. Press button to confirm.
5. Follow the instructions of the display to change the settings.
6. Press button ; a message appears on the display confirming your selection.
N.B.: When the oven is switched off, if the ECOMODE (energy saving) function is activated, the display switches
off after a few seconds and the clock is displayed. To show information on the display and switch on the light,
press a button or turn one of the knobs. When ECOMODE is activated during cooking the oven light is switched
off after a minute and lit again when the user adjusts the oven controls.
KEY-LOCK
This function can be used to lock the buttons and knobs on the control panel.
To activate it, press and at the same time for at least 3 seconds. If activated, the functions of the buttons
are locked and the display shows a message and the symbol . This function can also be activated during
cooking. To deactivate it, repeat the above procedure. When the key-lock function is activated, the oven can
be switched off by turning the knob to 0 (zero). In this case, however, the previously selected function will have
to be set again.
AUTOMATIC OVEN CLEANING
For a description of this function, see the section CLEANING and the Table of Functions on page 18.
To start automatic cleaning (pyrolysis) follow these steps:
1. Select “CLEANING” by turning the “Functions” knob. The display shows the texts “Pyro Express” and “Pyro”.
2. Select one of the two cleaning cycles using the “Browse” knob. Confirm with button .
3. Turn the “Browse” knob to position the cursor at “Start” and then press .
4. The display shows instructions for the actions to be taken before starting the cycle. After each action,
confirm with button
.
5. Following the last confirmation the oven is ready to start the cycle, and the door is locked: the display
shows a warning message and the symbol
for about three seconds. Then a progress bar is displayed for
the ongoing cleaning cycle.
N.B.: When you have closed the door again you must press the button again to start the cycle. If
the oven door is opened before it has been automatically locked the display shows a warning message.
6. When the cleaning cycle is complete a flashing message is shown on the display. Then a cooling bar is
displayed to show that the oven is cooling down. The residual temperature in the oven is shown on the
display together with the symbol
. The door remains locked until the oven temperature has dropped
below the safety level: then the current time is shown on the display.
TIME
Cleaning
- 03:00
END TIME
15:00
3 hours high temperature cleaning
Pyro Express
Pyro
1/3
Please switch o cooktop
above oven and press
✓
2/3
Please remove all accessories
from the oven and press
✓
3/3
Remove stains from glass
with moist sponge, press
✓
Door will be locked
during cleaning
TIME
Cleaning
- 02:59
END TIME
15:00
Please close door
TIME
Finished
- 00:00
END TIME
15:00
Cooling Down
257°
18:32