Instruction for Use

CONTROLS

The hood is fitted with a control panel with aspiration speed selection control and

a light switch to control cooking area lights.

To select hood functions, simply touch the controls:

T1. Button ON/OFF suction motor

T2. Button to select medium suction speed (power)

T3. Button to select high and intensive suction speed (power)

Press once to select high suction speed (power) (LED L3 on);

Press again to select intensive suction speed (power) (LED L3 flashing).

Note: The intensive suction (power) speed lasts for approximately 5

minutes, then the high suction speed (power) is set automatically.

T4. Automatic shutdown button (Timer) and saturation indicator for

charcoal filter:

Automatic shutdown:

Press this button to set the automatic shutdown of the active suction speed

(power):

Silent suction speed (power): 10 minutes

Medium suction speed (power): 20 minutes

High suction speed (power): 15 minutes

Saturation indicator charcoal filter

When flashing, perform maintenance of the charcoal filter, if installed, then

keep the button T6 pressed for a long time to stop the flashing.

T5. Button to select ‘silent’ suction speed (power) and saturation indicator

for grease filter

Note: when flashing, perform maintenance of the grease filter; then keep

the button T6 pressed for a long time to stop the flashing.

T6. Button ON/OFF lighting

T3+T4+T5 flashing: automatic operation under high temperature conditions (see

relevant paragraph)

Activation of the charcoal filter saturation indicator

This indicator is normally deactivated. To activate it, proceed as follows:

With the hood off, press and keep pressed simultaneously T4 and T5: T5

starts flashing first, then T4 as well, to indicate successful activation.

Deactivation of charcoal filter saturation LED: repeat the operation

described above; T5 and T4 start flashing, then only T5 to indicate

successful deactivation.

Automatic operation under high temperature conditions

The hood is equipped with a sensor which detects the temperature. When this

becomes too high, the sensor automatically turns on the medium suction speed

(power). The hood turns off as soon as the temperature detected by the sensor

is lowered significantly.