Installation guide

Electrical Shock Hazard
Electrically ground range.
Failure to feiow these instructions can result in death,
fire, or electrical shock.
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine that
the ground path and wire gauge are in accordance with local
codes.
Be sure that the electrical connection and wire size are adequate
and in conformance with CSA Standard C22.1, Canadian
Electrical Code, Part 1 - latest edition, and all local codes and
ordinances.
A copy of the above code standards can be obtained from:
Canadian Standards Association,
178 Rexdale Blvd.,
Toronto, ON M9W 1R3 CANADA.
• Do not ground to a gas pipe.
• Check with a qualified electrical installer if you are not sure
the range is properly grounded.
• Do not have a fuse in the neutral or ground circuit.
When a 4-wire, single phase 120/240 volt, 60 Hz., AC only
electrical supply is available, a 50-amp maximum circuit
protection is required (or, if specified on the model/serial
rating plate, when a 4-wire, single phase 120/208 volt 60 Hz.,
AC only electrical supply is available, a 40-amp maximum
circuit protection is required), fused on both sides of the line.
• A time-delay fuse or circuit breaker is recommended.
This range is equipped with a CSA International Certified
Power Cord intended to be plugged into a standard 14-50R
wall receptacle. Be sure the wall receptacle is within reach of
range's final location.
@
• Do not use an extension cord.
The cooktop sides of the slide-in range fit over the cutout edge of
your countertop.
22 sA"
(s7.8om_ i
If you have a square finish (flat) countertop and the opening width
is 30" (76.2 cm), no countertop preparation is required.
Formed front-edged countertops must have molded edge
shaved flat 3/8"(1.0 cm) from each front corner of opening.
Tile countertops may need trim cut back 8/8"(1.0 cm) from each
front corner and/or rounded edge flattened.
\
If countertop opening width is greater than 30" (76.2 cm), adjust
the %" (1.0 cm) dimension.
Countertop must be level. Place level on countertop, first side to
side; then front to back. If countertop is not level, range will not
be level. Oven must be level for satisfactory baking conditions.