Installation guide

5. Lift up and remove oven bake burner cover.
6. Remove the 2 oven bake burner screws and set aside.
7. Swing the oven bake burner to the side and lift it off the oven
orifice and set aside.
10. Unscrew the regulator cap and remove the plastic cover.
A. Plastic cover
B. Regulator cap
11. Flip the regulator cap over and replace the plastic cover.
8=
9=
A. Oven bake bumer screws
B. Oven orifice
Locate the access panel at the rear of the storage drawer
compartment. Using a 1A" (6 mm) nut driver, unscrew the
2 access panel screws. Remove access panel and set aside
along with the 2 screws.
A
A. Access panel screws
Locate gas pressure regulator at the rear of the storage
drawer compartment.
B
A. LP gas position
B. Natural gas position
C. Plastic cover
12. Screw the regulator cap securely back into place. Do not
overtighten.
To Convert Oven Bake Burner
1. Locate the oven orifice hood from the front of the range.
2. Using an adjustable wrench, turn the Number .0512 LP gas
oven bake burner orifice hood counterclockwise to remove.
IMPORTANT: Do not remove the gas pressure regulator.
© ©
A, Number .0512 LP gas oven bake burner orifice hood
16