Installation guide

mCheckthatthetypeofgassupply
is correct for this range. (See
model/serial rating plate located on
oven frame behind storage drawer
panel.)
if connecting to L.P. Gas, fo++ow
directions in Conversion Kit included in
your literature package.
if connecting to Natural gas, go to
Step 8+
Tip Over Hazard
A chitd or adult can tip the range
and be killed.
Connect anti=tip bracket to rear
range foot.
Reconnect the anti=tip bracket, if
the range is moved.
Failure to follow these instructions
can result in death or serious
burns to chitdren and adults.
25" (63.5 cm)
countertop over
24" (61 cm)
_ cabinet
tip
_ _ bracket
"template
8[] PUacethe anti+tip bracket
tempUate on the floor in the cabinet
opening so that the ]eft edge is
against cabinets and the top edge is
against the rear vvaU],molding or
cabinet.
A
25" (63.5 cm)___ j+_ll -i
I
I
I
I
I
I
I
I
I
I
_Countertop
I overhangs
I cabinet side.
I
I A = Difference
I between
I countertop
I depth and 25"
I(63.5 cm}. #5,
....... anti=tip bracket
template
if countertop opening is deeper than
25 inches (63.5 cm), measure and
mark a distance 25 inches (63.5 cm)
in from front of countertop opening
and align template with mark (or
subtract 25 inches (63.5 cm) from
countertop depth and add the
difference to the corresponding
dimension).
if countertop is not flush to the side
of cabinet opening, align the left side
of the template to allow for the
countertop overhang.Tape the range
anti+tip bracket template in place.
Contact a qualified floor covering
installer for the best procedure of
drilling mounting holes through
your type floor covering.
9m Use the anti- "_
tip bracket template/
instruction sheet to
install the anti+tip
bracket.
Anti+tip bracket
must be anchored
securely to the
sub41oor.
Depending on the thickness of your
flooring, longer screws may be
necessary to anchor the bracket to
the sub+floor. Longer screws are
available from your local hardware
store.
To install the back cover trim piece:
Om Attach back cover trim piece
to the back of cooktop using three
screws supplied
vvith back
cover trim
piece.
Installed back cover
trim
Before moving range across floor,
check that range is still on cardboard
shipping base to protect floor
covering.
Move range
close to final
position. Remove
cardboard or
hardboard from under
range. Puii storage drawer open to
first stop position. Lift front of drawer
to clear white wheels in drawer
guides. Remove drawer and set it
aside on a protected surface.
bracket securely
attached to floor.
° Slide range back so rear range foot
is under anti+tip bracket.