Installation guide

Check location where range witl be instaIIed.The range should be Iocated
for convenient use in the kitchen. Recessed installations must provide
complete enclosure of the sides and rear of range.
All openings in the wail or floor where range is to be installed must be
sealed.
VYal[ outlet to be
located within the 30-3/8" (7-L2 cm)
18" x 10" _ width
(45.7 cm x 25.4 cm) ,12_
shaded area.
(57.1 crn)
6"
(15/2 era}
Gas line opening \,
to be located within 1
either 2-1/2" x 24"
(6.4 crn x 61 crn)
shaded area. -_ 1
Floor gas line--_-_... [
opening if directty "--_
below rec
IMPORTANT: Some cabinet and building materials are not designed to
withstand the heat produced by the oven for baking and self-cieaning.
Check with your builder or cabinet supplier to make sure that the
materials used wil[ not discolor, deiaminate or sustain other damage.
to
cabinet opening countertop
width
See NOTE *÷
(22.9 cm)
(25.4 cm)
2-1/2"
(6.4 cm)
*÷ NOTE
4" (10.2 cm) mira
clearance from
both sides of
range to side
wall or other
combustible
material
between upper
cabinet and
countertop
Do not pinch the power supply
cord between the range and the
wail.
Do not seal the range to the side
cabinets.
25" (63.5 cm) countertop depth
24" (61 cm) base cabinet depth
36" (91.4 cm) countertop height
When installed in a 24" (61 cm)
base cabinet with 25" (63.5 cm)
countertop-- front of oven door
protrudes 1-7/8" (4.8 cm) beyond
24" (61 crn) base cabinet.
NOTE: 24" (61 cm) rain. when
bottom of wood or metal cabinet
is protected by not less than 1/4"
(0.64 cm) flame retardant millboard
covered with not less than No. 28
MSG sheet steel, 0.015" (0.4 ram)
stainless steel, 0.024" (0.6 mm)
aluminum or 0.020"(0.5 ram}
copper.
30" (76.2 cm) rain. clearance
between the top of the cooking
platform and the bottom of an
unprotected wood or metal cabinet.
Contact a qualified floor covering
installer to check that the floor
covering can withstand at least
200°F (93°C).
Use an insulated pad or 1/4"
(.64 cm) plywood under range if
installing range over carpeting.
7/8" (2.2 crn) min. between
cabinet opening and cabinet
door or hinge
if your ___ntert_p cutout matches the cutouts shown, you need to instaii the back cover trim piece. (See Step 10.)
(2.5 cm}
No backsplash across
countertop cutout
The back cover trim piece wilI fit flush to
countertop and extend to back wall.
Backspiash installed across
countertop cutout
The back cover trim piece wiil fit flush to
countertop and underneath backsplash.