Manual

iiii: iii !ii;ilill?iil;ii!i iSIi!iiii i i iii !!i, iiiiii ii!iil
5. Test the flame by turning the control from "LO" to
"HI," checking the flame at each setting.
Low flame
!.rl_l Ln_l Ln_l I.rLI Ln_l
...................f-
Port
High flame
Ln_l Ln_l Ln_l Ln_l
1. Open the door to the Broil Stop position (open
about 4" [10 cm]).
2. Lift door slightly and pull out and back until
hinges come out to the catch position.
3. Push door down and pull straight out to remove
door completely.
1. Holding the door by the handle, place the top of
the door under the cooktop overhang and use
your leg to apply pressure to slide hinges into
the slots as far as possible.
2. Open door to the broil position or slightly past it.
3. Using the side of your leg, apply pressure to the
bottom of the door front. Lift the door slightly
while applying pressure to push, until the hinges
have gone in fully.
The control console glass can be removed to allow
easy cleaning of both sides of the glass and the
control panel.
Use a sponge with warm, soapy water. Do not
clean the electronics behind the glass. Liquids can
damage the electronics.
To remove the control console glass:
1. Remove surface element control knobs by
pulling them straight out.
2. Release console clips and remove the control
console glass by pulling it slightly up and
forward.
31