Installation guide

Wiring configuration
Power supply wire: Terminal box-wire:
white ~<——— white
black <«———»» black
ground wire ~«———»» ground connector
If needed, see website for animated representation
of this step. Visit www.whirlpool.com/electrical under
FAQ tab.
Direct Wire—Secure cable
in strain relief
Direct Wire—Reinstall
terminal box cover
B
Place wires inside terminal box. Insert tabs on left side
of cover. Make sure wires are tucked inside box. Close
cover ensuring wires are not pinched. Use 4" nut driver
and previously removed screw to secure cover.
ecure Dishwasher in Cabinet
Opening
Double-check dishwasher
alignment in cabinet opening
Check that dishwasher is still level front-to-back and
side-to-side in cabinet opening.
Remove lower dish rack
and place towel
Open dishwasher door, remove lower dish rack, and
place towel over pump assembly and lower spray arm of
dishwasher. This will prohibit screws from falling into
pump area when securing dishwasher to countertop.
screw to
side cabinet
NOTE: Do not drop screws into bottom of dishwasher.
Locate brackets on top of dishwasher and secure
dishwasher to countertop with two, #10 x 4%" Phillips-head
screws (included). The dishwasher must be secured to
keep it from shifting when door is opened.
19