Installation guide

IMPORTANT:Ifwheelswereremoved,coverthefloorwhen
movingthedishwashertoavoiddamagetothefloor.Slowly
movedishwashercompletelyintocabinetopening.Donotkinkor
pinchwaterline,drainhose,powersupplycordordirectwire
betweendishwasherandcabinet.Removecardboardfromunder
dishwasher.
NOTE:Itisallrightifdishwasherfitstightlyintocabinetopening.
Donotremoveinsulationblanket- theblanketreducesthe
soundlevel.
NOTE:Ifusingpowercord,makesuretorouteendthroughhole
incutoutbeforeslidingintocabinetopening.
Alignfrontofdishwasherdoorpanelwithfrontofcabinetdoors.
Youmayneedtoadjustalignmenttobeevenwithyour
cabinets.
Checkthatlevelinglegsarefirmlyagainstthefloor.
Closeandlatchthedoor,andplacelevelagainstthe
frontpanel.Checkthatdishwasheriscenteredfromfronttoback
intheopening.Ifneeded,adjustlevelingleguntildishwasheris
plumb.Repeatforothersideofdishwasher.
HeJpfuJTip:Pushuponfrontofdishwashertoraisedishwasher
offthegroundtoadjustfrontlegs.Withsomeinstallations,it
maybeeasiertoadjustthefrontlegusingthe3A6"hexhead
socketoradjustablewrench.
Placelevelagainsttopfrontopeningoftub.Check
thatdishwasherislevelfromsidetoside.Ifdishwasherisnot
level,adjustfrontlegsupordownuntildishwasherislevel.
Connect to Water Supply
Be sure rubber washer is properly seated in fitting. Slide the 3/4"
fitting up to the valve and hand tighten to avoid unintentional
cross-threading. Hand tighten until the coupling is tight. Using
pliers, check the tightness of the coupling. An additional 1/4to 1/2
turn may be required to seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can result.
Place paper towel under 90 ° elbow fitting. Turn on water
supply and check for leaks. If leak occurs, repeat previous step.
If needed, see website for animated representation
of this step. Visit www.whirlpool.com/watersupply under
FAQ tab.
NOTE: Do not use Teflon _>ttape with compression fittings.
1-_TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
15